Service Loopback Group Configuration Example; Network Requirements; Configuration Procedure - HP FlexFabric 12900 Series Configuration Manual

Task
Display information about the service loopback group.

Service loopback group configuration example

Network requirements

All Ethernet ports on Device A support the tunnel service.
Assign Ten-GigabitEthernet 1/0/1 through Ten-GigabitEthernet 1/0/3 to a service loopback group to
loop GRE packets sent out by the device back to the device.

Configuration procedure

# Create service loopback group 1, and specify its service type as tunnel.
<DeviceA> system-view
[DeviceA] service-loopback group 1 type tunnel
# Assign Ten-GigabitEthernet 1/0/1 through Ten-GigabitEthernet 1/0/3 to service loopback group 1.
[DeviceA] interface ten-gigabitethernet 1/0/1
[DeviceA-Ten-GigabitEthernet1/0/1] port service-loopback group 1
[DeviceA-Ten-GigabitEthernet1/0/1] quit
[DeviceA] interface ten-gigabitethernet 1/0/2
[DeviceA-Ten-GigabitEthernet1/0/2] port service-loopback group 1
[DeviceA-Ten-GigabitEthernet1/0/2] quit
[DeviceA] interface ten-gigabitethernet 1/0/3
[DeviceA-Ten-GigabitEthernet1/0/3] port service-loopback group 1
[DeviceA-Ten-GigabitEthernet1/0/3] quit
# Create the interface Tunnel 1 and set it to GRE mode. The interface will automatically use service
loopback group 1.
[DeviceA] interface tunnel 1 mode gre
[DeviceA-Tunnel1]
Command
display service-loopback group [ number ]
209