Calculation Process Of The Stp Algorithm - HP FlexFabric 12900 Series Configuration Manual

Figure 17 Designated bridges and designated ports
Device B
Port B2
Path cost
Path cost is a reference value used for link selection in STP. To prune the network into a loop-free tree, STP
calculates path costs to select the most robust links and block redundant links that are less robust.

Calculation process of the STP algorithm

The spanning tree calculation process described in the following sections is an example of a simplified
process.
Calculation process
The STP algorithm uses the following calculation process:
1. Initialize the network.
Upon initialization of a device, each port generates a BPDU with the following contents:
The port as the designated port.
The device as the root bridge.
0 as the root path cost.
The device ID as the designated bridge ID.
Select the root bridge.
2.
Initially, each STP-enabled device on the network assumes itself to be the root bridge, with its own
device ID as the root bridge ID. By exchanging configuration BPDUs, the devices compare their
root bridge IDs to elect the device with the smallest root bridge ID as the root bridge.
3. Root port and designated ports selection on the non-root bridges.
Step
1
Device A
Port A1
Port A2
Port B1 Port C1
Port C2
LAN
Description
A non-root–bridge device regards the port on which it received the optimum configuration
BPDU as the root port. Table 5
Device C
describes how the optimum configuration BPDU is selected.
68