Displaying And Maintaining Ethernet Link Aggregation; Ethernet Link Aggregation Configuration Examples; Layer 2 Static Aggregation Configuration Example - HP FlexFabric 12900 Series Configuration Manual

Displaying and maintaining Ethernet link
aggregation
Execute display commands in any view and reset commands in user view.
Task
Display information for an aggregate interface
or multiple aggregate interfaces.
Display the local system ID.
Display the global or group-specific
link-aggregation load sharing modes.
Display detailed link aggregation information
for link aggregation member ports.
Display summary information about all
aggregation groups.
Display detailed information about the specified
aggregation groups.
Clear LACP statistics for the specified link
aggregation member ports.
Clear statistics for the specified aggregate
interfaces.

Ethernet link aggregation configuration examples

Layer 2 static aggregation configuration example

Network requirements
On the network shown in
• Configure a Layer 2 static aggregation group on both Device A and Device B.
Enable VLAN 10 at one end of the aggregate link to communicate with VLAN 10 at the other end.
•
Enable VLAN 20 at one end of the aggregate link to communicate with VLAN 20 at the other end.
•
Command
display interface [ bridge-aggregation ] [ brief [ down |
description ] ]
display interface bridge-aggregation interface-number
[ brief [ description ] ]
display lacp system-id
display link-aggregation load-sharing mode [ interface
[ bridge-aggregation interface-number ] ]
display link-aggregation member-port [ interface-list ]
display link-aggregation summary
display link-aggregation verbose [ bridge-aggregation
[ interface-number ] ]
reset lacp statistics [ interface interface-list ]
reset counters interface [ bridge-aggregation
[ interface-number ] ]
Figure 12, perform the following tasks:
54