Assigning A Hybrid Port To A Vlan - HP FlexFabric 12900 Series Configuration Manual

Step
2. Enter interface view.
3. Configure the link type of the
port as trunk.
4. Assign the trunk port to the
specified VLANs.
5. (Optional.) Configure the
PVID of the trunk port.

Assigning a hybrid port to a VLAN

A hybrid port supports multiple VLANs. You can assign it to the specified VLANs in interface view. Make
sure the VLANs have been created.
When you assign a hybrid port to a VLAN, follow these guidelines:
To change the link type of a port from trunk to hybrid or vice versa, set the link type to access first.
•
To enable a hybrid port to transmit packets from its PVID, you must assign the hybrid port to the PVID
•
by using the port hybrid vlan command.
To assign a hybrid port to one or multiple VLANs:
Step
1. Enter system view.
Command
•
Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
•
Enter Layer 2 aggregate
interface view:
interface bridge-aggregation
interface-number
•
Enter S-channel interface view:
interface s-channel
interface-number.channel-id
•
Enter S-channel aggregate
interface view:
interface
schannel-aggregation
interface-number:channel-id
port link-type trunk
port trunk permit vlan { vlan-id-list
| all }
port trunk pvid vlan vlan-id
Command
system-view
130
Remarks
•
The configuration made in
Layer 2 Ethernet interface view
applies only to the port.
•
The configuration made in
Layer 2 aggregate interface
view applies to the aggregate
interface and its aggregation
member ports. If the system fails
to apply the configuration to an
aggregation member port, it
skips the port and moves to the
next member port. If the system
fails to apply the configuration
to the aggregate interface, it
stops applying the
configuration to aggregation
member ports.
•
The configuration made in
S-channel interface view or
S-channel aggregate interface
view applies only to the
interface. For more information
about S-channel interfaces, see
EVB Configuration Guide.
By default, all ports are access
ports.
By default, a trunk port permits only
VLAN 1.
The default setting is VLAN 1.
Remarks
N/A