Configuring An Mst Region - HP FlexFabric 12900 Series Configuration Manual

RSTP mode—All ports of the device send RSTP BPDUs. A port in this mode automatically transits to
•
the STP mode when it receives STP BPDUs from the peer device. A port in this mode does not transit
to the MSTP mode when it receives MSTP BPDUs from the peer device.
• MSTP mode—All ports of the device send MSTP BPDUs. A port in this mode automatically transits
to the STP mode when receiving STP BPDUs from the peer device. A port in this mode does not
transit to the RSTP mode when receiving RSTP BPDUs from the peer device.
PVST mode—All ports of the device send PVST BPDUs. Each VLAN maintains a spanning tree. In a
•
network, the amount of spanning trees maintained by all devices equals the number of
PVST-enabled VLANs multiplied by the number of PVST-enabled ports. If the amount of spanning
trees exceeds the capacity of the network, device CPUs will be overloaded. Packet forwarding is
interrupted, and the network becomes unstable. The number of spanning trees that a device can
maintain is 128.
The MSTP mode is compatible with the RSTP mode, and the RSTP mode is compatible with the STP mode.
Compatibility of the PVST mode depends on the link type of a port.
On an access port, the PVST mode is compatible with other spanning tree modes in all VLANs.
•
On a trunk port or hybrid port, the PVST mode is compatible with other spanning tree modes only
•
in VLAN 1.
To set the spanning tree mode:
Step
Enter system view.
1.
2. Set the spanning tree mode.

Configuring an MST region

Spanning tree devices belong to the same MST region if they are both connected through a physical link
and configured with the following details:
Format selector (0 by default, not configurable).
•
• MST region name.
MST region revision level.
•
VLAN-to-instance mapping entries in the MST region.
•
The configuration of MST region-related parameters (especially the VLAN-to-instance mapping table)
might cause MSTP to begin a new spanning tree calculation. To reduce the possibility of topology
instability, the MST region configuration takes effect only after you activate it by doing one of the
following:
Use the active region-configuration command.
•
• Enable a spanning tree protocol by using the stp global enable command if the spanning tree
protocol is disabled.
In STP, RSTP, or PVST mode, MST region configurations do not take effect.
To configure an MST region:
Command
system-view
stp mode { mstp |pvst | rstp | stp }
85
Remarks
N/A
The default setting is the
MSTP mode.