Step
2.
Enter Layer 2 aggregate
interface view.
3.
Set the minimum number of
Selected ports for the
aggregation group.
4.
Set the maximum number of
Selected ports for the
aggregation group.
Configuring the expected bandwidth of an aggregate interface
To set the expected bandwidth of an aggregate interface:
Step
1.
Enter system view.
2.
Enter Layer 2 aggregate
interface view.
3.
Configure the expected
bandwidth of the interface.
Configuring an edge aggregate interface
When you configure an edge aggregate interface, follow these restrictions and guidelines:
This configuration takes effect only on the aggregate interface corresponding to a dynamic
•
aggregation group.
•
Link-aggregation traffic redirection does not operate correctly on an edge aggregate interface. For
more information about link-aggregation traffic redirection, see
redirection."
To configure an edge aggregate interface:
Step
1.
Enter system view.
2.
Enter Layer 2 aggregate
interface view.
3.
Configure the aggregate
interface as an edge
aggregate interface.
Command
interface bridge-aggregation
interface-number
link-aggregation selected-port
minimum number
link-aggregation selected-port
maximum number
Command
system-view
interface bridge-aggregation
interface-number
bandwidth bandwidth-value
Command
system-view
interface bridge-aggregation
interface-number
lacp edge-port
49
Remarks
N/A
By default, the minimum number of
Selected ports for the aggregation
group is not specified.
By default, the maximum number of
Selected ports for an aggregation
group is 32.
Remarks
N/A
N/A
By default, the expected
bandwidth (in kbps) is the interface
baud rate divided by 1000.
"Enabling link-aggregation traffic
Remarks
N/A
N/A
By default, an aggregate interface
does not operate as an edge
aggregate interface.