Juniper EX4200-24T Hardware Manual page 218

EX4200 Switch Hardware Guide
196
To remove a transceiver from a device:
Place the antistatic bag or antistatic mat on a flat, stable surface.
1.
Label the cable connected to the transceiver so that you can reconnect it correctly.
2.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables
connected to transceivers emit laser light that can damage your eyes.
WARNING: Do not leave a fiber-optic transceiver uncovered except when
inserting or removing a cable. The rubber safety cap keeps the port clean
and prevents accidental exposure to laser light.
CAUTION: Do not bend fiber-optic cables beyond their minimum bend
radius. An arc smaller than a few inches in diameter can damage the cables
and cause problems that are difficult to diagnose.
Remove the cable connected to the transceiver (see
3.
Cable from a Device" on page
cable connector with a rubber safety cap immediately after disconnecting the
fiber-optic cables.
"Disconnecting a Fiber-Optic
200). Cover the transceiver and the end of each fiber-optic
Copyright © 2017, Juniper Networks, Inc.