Network Port Leds In Ex4200 Switches; Figure 10: Leds On The Management Port On An Ex4200 Switch; Table 8: Link/Activity Led On The Management Port On Ex4200 Switches; Table 9: Status Led On The Management Port On Ex4200 Switches - Juniper EX4200-24T Hardware Manual

EX4200 Switch Hardware Guide

Table 8: Link/Activity LED on the Management Port on EX4200 Switches

LED
Link/Activity

Table 9: Status LED on the Management Port on EX4200 Switches

LED
Status
Related
Documentation

Network Port LEDs in EX4200 Switches

24

Figure 10: LEDs on the Management Port on an EX4200 Switch

Table 8 on page 24 describes the Link/Activity LED.
Color
Green
Table 9 on page 24 describes the Status LED (administrative status).
Color
Green
See Rear Panel of an EX4200 Switch on page 12
Connecting a Device to a Network for Out-of-Band Management on page 157
Each network port on the switch has two LEDs. The four figures in this topic show the
location of those LEDs:
Figure 11 on page 25 shows the location of the LEDs on the network ports on the front
panel.
Figure 12 on page 25 shows the location of the LEDs on the uplink module ports on the
SFP uplink module.
State and Description
Blinking—The port and the link are active, and there is link
activity.
On steadily—The port and the link are active, but there is no
link activity.
Off—The port is not active.
State and Description
On steadily—Administrative status is enabled.
Off—Administrative status is disabled.
for port location.
Copyright © 2017, Juniper Networks, Inc.