Table 28: Chassis Viewer For Ex8208 Switches - Juniper EX4200-24T Hardware Manual

EX4200 Switch Hardware Guide
Table 27: Chassis Viewer for EX6210 Switches (continued)
Field Description
Interface status Select the CB or line card.
In the image, the colors listed below denote the interface status:
Green—Interface is up and operational.
Yellow—Interface is up but is nonoperational.
Gray—Interface is down and nonoperational.
Mouse over the interface (port) to view more information.
You can view status for the following ports on the SRE module:
USB port—Indicates the USB port for the switch.
NOTE:
EX Series switch.
Management (
device for out-of-band management. There are 2 management ports: fiber and copper. The same
status is displayed for both the
Console port—The console port is used to connect the switch to a management console or to a
console server. (You might do this for initial switch configuration.)
CBs support 4 SFP+ uplink ports. Mouse over the interface on the CB for more information.
For SFP and SFP+ ports, the interfaces appear dimmed if no transceiver is inserted. The chassis viewer
displays
Power supplies Mouse over the power supply icons to display name, status, and description information.
LCD panel LCD panel configured for the LEDs on the ports. Mouse over the icon to view the current character
display of the master Routing Engine. The EX6210 switch has 2 LCD panels, one for each Routing Engine.
The backup Routing Engine LCD displays
Rear View of the EX6210 Switch
Fan tray Mouse over the fan tray icon to display information regarding the cooling fans.

Table 28: Chassis Viewer for EX8208 Switches

Field Description
Front View
54
We recommend that you use USB flash drives purchased from Juniper Networks for your
me0 ) port—The management port is used to connect the switch to a management
me0
when you mouse over the port icon.
Transceiver not plugged-in
ports.
.
Backup
Copyright © 2017, Juniper Networks, Inc.