Create A Hardware Raid Volume - Oracle SPARC Administration Manual

Create a Hardware RAID Volume

...
5.
Use the OpenBoot select command to specify the controller where you want to
create a hardware RAID volume.
ok select /pci@300/pci@1/pci@0/pci@4/scsi@0
Instead of using the entire device path for the controller, you can use a preconfigured alias for a
controller. For example:
ok select scsi_alias
where scsi_alias corresponds to a preconfigured alias you had previously created for your path.
Note -
See "Locate Device Paths (OpenBoot)" on page
6. If you decide to select a different controller after performing
unselect the current controller.
ok unselect-dev
Now you can select a different controller, as described in
based RAID commands that apply to the selected controller.
7. Continue to create a hardware RAID volume on the selected controller.
See "Create a Hardware RAID Volume" on page
Related Information
"Obtain the OpenBoot Prompt Under Various Conditions" on page 19
■
"FCode-Based RAID Utility Commands" on page 84
■
"Locate Device Paths (OpenBoot)" on page 72
■
Create a Hardware RAID Volume
Select the controller that will handle a new RAID volume.
1.
See "Prepare to Create a RAID Hardware Volume (FCode-based RAID
Utility)" on page
selected an on-board disk controller.
86 SPARC and Netra SPARC T5 Series Servers Administration Guide • August 2016
To view the preconfigured aliases on the server, use the OpenBoot devalias command.
85. At this point you have obtained the OpenBoot prompt and have
72.
Step
Step 5. You can then run other FCode-
86.
5, you must