Printenv Output - Oracle SPARC Administration Manual

View All OpenBoot Parameters
Parameter
boot-device
boot-file
diag-switch?
network-boot-arguments
Related Information
"printenv Output" on page 48
■

printenv Output

This output is a sample from the OpenBoot command printenv. The output for each server
might be different.
{0} ok printenv
Variable Name
ttya-rts-dtr-off
ttya-ignore-cd
keyboard-layout
reboot-command
security-mode
security-password
security-#badlogins
verbosity
diag-switch?
local-mac-address?
fcode-debug?
scsi-initiator-id
oem-logo
oem-logo?
48 SPARC and Netra SPARC T5 Series Servers Administration Guide • August 2016
Default Value Description
■ boot disk1:h – Boots from disk 1 partition h.
■ boot tape – Boots default file from tape.
■ boot device-path – Boots from the device specified as device-path. See
"Locate Device Paths (OpenBoot)" on page
Contains the name of the default boot device that is used when OpenBoot is not
disk net
in diagnostic mode.
An optional parameter that provides boot arguments that are used when
OpenBoot is not in diagnostic mode.
If the value is true, runs in the Diagnostic mode.
false
An optional parameter that enables you to set configuration parameters to be
used by OpenBoot when you perform a WAN boot. Setting this parameter
takes precedence over any default boot parameter values. Refer to the
eeprom(1M) man page for details.
Value
false
true
none
0
min
false
true
false
7
false
72.
Default Value
false
true
No default
No default
No default
min
false
true
false
7
No default
false