Wwn Syntax In An Oracle Solaris 10 Installation On An Individual Drive - Oracle SPARC Administration Manual

WWN Syntax in an Oracle Solaris 10 Installation on an Individual Drive

In this example, the obp-path is:
/pci@400/pci@1/pci@0/pci@0/LSI,sas@0/disk@w5000cca00abbaeb9,0
Based on the earlier name identification, this disk is on controller 0.
4.
Consult this port mapping table to determine which physical disk slot the phy-num
value corresponds to.
This phy-num value corresponds to physical disk slot 0.
SAS Controller
†
Default boot drive
Related Information
"WWN Syntax" on page 70
■
"probe-scsi-all Device Naming (OpenBoot)" on page 74
■
"WWN Syntax in an Oracle Solaris 10 Installation on an Individual Drive" on page 78
■
"WWN Syntax in an Oracle Solaris 10 Installation on a RAID Volume" on page 79
■
WWN Syntax in an Oracle Solaris 10 Installation on an
Individual Drive
The following Oracle Solaris 10 Jumpstart profile example shows details of the WWN syntax
for installing the operating system on a specific disk drive. In this example, the device name
contains the WWN value 5000CCA00A75DCAC.
Note -
profile.
78 SPARC and Netra SPARC T5 Series Servers Administration Guide • August 2016
name='path-class' type=string items=1
value='primary'
PhyNum
0 0
1
2
3
All alpha characters in the WWN value must be capitalized when included in a Jumpstart
SAS Controller
Disk Slot
†
0 1
1
2
3
PhyNum Disk Slot
0 4
1 5
2 6
3 7