Specify Host Virtual Keyswitch Behavior; Reset The Values In The Sp To Default Values - Oracle SPARC Administration Manual

Specify Host Virtual Keyswitch Behavior

Use the /HOST keyswitch_state property to control the position of the virtual keyswitch.
At the Oracle ILOM prompt, type:
-> set /HOST keyswitch_state=value
where value can be:
normal – (Default) The server can power itself on and start the boot process.
■
standby – Powers off the host, and disables power on.
■
diag – Host power on is allowed. This value overrides the settings of /HOST/diag target,
■
resulting in Max POST being executed.
locked – Host power on is allowed, however, you are prohibited from updating flash
■
devices or setting /HOST send_break_action=break.
Related Information
"Power On the Server (Oracle ILOM Web Interface)" on page 25
■
"Power On the Server (Oracle ILOM CLI)" on page 24
■
"Power Off the Server (Oracle ILOM Web Interface)" on page 26
■
"Power Off the Server (Oracle ILOM CLI)" on page 24
■

Reset the Values in the SP to Default Values

If your SP becomes corrupt, or you want to reset the SP to the factory default values, you must
change the /SP reset_to_defaults setting, then power off the host to implement the changes.
This behavior is new. Previously you did not have to power off the host to reset default values
to the SP.
You need administrator permissions to perform this task.
Log in to Oracle ILOM.
1.
See "Log In to Oracle ILOM" on page
If you have a modular system, ensure that you are logged in to the desired server
Note -
module.
Specify Host Virtual Keyswitch Behavior
17.
Configuring Policy Settings 61