Raidconfig Commands; Raid Capabilities In Oracle Enterprise Manager Ops Center - Oracle SPARC Administration Manual

When you get firmware updates for the on-board SAS controllers, you must acquire
Caution -
them from Oracle's support site, https://support.oracle.com. Firmware applied to the on-
board SAS controllers that was obtained from any other location or any vendor other than
Oracle is not supported.

raidconfig Commands

You can use the raidconfig commands contained in the Oracle Hardware Management Pack.
Use the Oracle Server CLI Tools component to create and manage RAID volumes on the server.
To use these commands, download and install Oracle Hardware Management Pack software
that supports the server. To install the software, refer to the Oracle Hardware Management
Pack Installation Guide for your version at:
http://www.oracle.com/goto/ohmp/docs
RAID Capabilities in Oracle Enterprise Manager
Ops Center
You can create RAIDs and manage existing RAIDs with Oracle Enterprise Manager Ops
Center. If you reconfigure an existing RAID with Oracle Enterprise Manager Ops Center, the
contents of the disks in the original RAID will be lost.
For more about Oracle Enterprise Manager Ops Center, see
Center Overview" on page
Related Information
"Create a Hardware RAID Volume" on page 86
■
"Prepare to Create a RAID Hardware Volume (FCode-based RAID Utility)" on page 85
■
"Oracle Hardware Management Pack Overview" on page 15
■
"Oracle Enterprise Manager Ops Center Overview" on page 16
■
16.
Hardware RAID Support
"Oracle Enterprise Manager Ops
Configuring Hardware RAID 83