Configure The Host Boot Mode (Oracle Vm Server For Sparc) - Oracle SPARC Administration Manual

Configure the Host Boot Mode (Oracle VM Server for SPARC)

forgetting about it, a bootmode state property expires if the host is not reset within 10 minutes of
the bootmode state property being set.
Related Information
"Reset the Server (Oracle Solaris)" on page 30
■
"Reset the Server (Oracle ILOM)" on page 30
■
"OpenBoot Overview" on page 13
■
"Oracle VM Server for SPARC Overview" on page 13
■
Configure the Host Boot Mode (Oracle VM Server for
SPARC)
Note -
1. Log in to Oracle ILOM.
See "Log In to Oracle ILOM" on page
2. Determine the valid Oracle VM Server configurations on your SP.
-> show /HOST/domain/configs
3. Set the boot mode configuration at the Oracle ILOM prompt.
-> set /HOST/bootmode config=configname
where configname is a valid named logical domain configuration.
For example, if you created a Oracle VM Server configuration called ldm-set1:
-> set /HOST/bootmode config=ldm-set1
To return the boot mode config to the factory default configuration, specify factory-default:
-> set /HOST/bootmode config=factory-default
Related Information
"Reset the Server (Oracle ILOM)" on page 30
■
"Boot Mode Overview (Oracle ILOM)" on page 49
■
"Oracle VM Server for SPARC Overview" on page 13
■
50 SPARC and Netra SPARC T5 Series Servers Administration Guide • August 2016
You must use a valid Oracle VM Server configuration name for this task.
17.