Table of Contents
Advertisement
VIPA System 300S
Byte
Bit 7 ... Bit 0
0
Reaction to CPU Stop
n
Bit 0: Keep last valid value
n
Bit 1: Substitute a value
n
Bit 6: reserved
n
Bit 7: reserved
1
Substitute value
n
Bit 0: Substitute value "1" on channel 0
n
Bit 1: Substitute value "1" on channel 1
n
Bit 2: Substitute value "1" on channel 2
n
Bit 3: Substitute value "1" on channel 3
n
Bit 4: Substitute value "1" on channel 4
n
Bit 5: Substitute value "1" on channel 5
n
Bit 6: Substitute value "1" on channel 6
n
Bit 7: Substitute value "1" on channel 7
2
not relevant
3
not relevant
Reaction to CPU-Stop
4.7.2 Technical data
Order no.
Type
SPEED-Bus
Current consumption/power loss
Current consumption from backplane bus
Power loss
Technical data digital outputs
Number of outputs
Cable length, shielded
Cable length, unshielded
HB140 | SM-DIO | | en | Rev. 16-43
You should only enable the parameters in byte 0, "Hold last valid value"
and "Enable substitute value" as an alternative.
Here the module reaction at CPU-STOP may be set. There are the following possibilities:
n
Keep last valid value
–
The value of each channel is frozen when the CPU is stopped
n
Substitute a value
–
At CPU-STOP each channel is substituted by a value which may be assigned by
byte 1.
322-5FF00 - DO 8xAC 120/230V 2A > Technical data
322-5FF00
SM 322
-
100 mA
8.6 W
8
1000 m
600 m
Digital Output Modules
Default value
00h
00h
00h
00h
63
Advertisement
Table of Contents
