Table of Contents
Advertisement
VIPA System 300S
CageClamp technology
(green)
Front connectors of the
in-/output modules
HB140 | SM-DIO | | en | Rev. 16-43
For the cabling of power supply of a CPU, a green plug with CageClamp technology is
deployed. The connection clamp is realized as plug that may be clipped off carefully if it is
still cabled.
Here wires with a cross-section of 0.08mm
flexible wires without end case as well as stiff wires.
1
Test point for 2mm test tip
2
Locking (orange) for screwdriver
3
Round opening for wires
The picture on the left side shows the cabling step by step from top view.
1.
For cabling you push the locking vertical to the inside with a suiting screwdriver and
hold the screwdriver in this position.
2.
Insert the de-isolated wire into the round opening. You may use wires with a cross-
section from 0.08mm
3.
By removing the screwdriver the wire is connected safely with the plug connector
via a spring.
In the following the cabling of the two variants are shown.
Assembly and installation guidelines
2
to 2.5mm
2
2
to 2.5mm
2
may be connected. You can use
Cabling
17
Advertisement
Table of Contents
