Table of Contents
Advertisement
Assembly and installation guidelines
Cabling
20pole screw connection
392-1AJ00
18
1.
Open the front flap of your I/O module.
2.
Bring the front connector in cabling position.
For this you plug the front connector on the module until it locks. In this position the
front connector juts out of the module and has no contact yet.
3.
De-isolate your wires. If needed, use core end cases.
4.
Thread the included cable binder into the front connector.
5.
If you want to lead out your cables from the bottom of the module, start with the
cabling from bottom to top, res. from top to bottom, if the cables should be led out at
the top.
6.
Bolt also the connection screws of not cabled screw clamps.
7.
Fix the cable binder for the cable bundle.
8.
Push the release key at the front connector on the upper side of the module and at
the same time push the front connector into the module until it locks.
9.
Now the front connector is electrically connected with your module.
10.
Close the front flap.
11.
Fill out the labeling strip to mark the single channels and push the strip into the front
flap.
VIPA System 300S
HB140 | SM-DIO | | en | Rev. 16-43
Advertisement
Table of Contents
