Troubleshooting Flowchart; Solution - HPE FlexNetwork 10500 SERIES Troubleshooting Manual

Troubleshooting flowchart

Figure 30 Troubleshooting interface assignment failure
Interface assignment failure
Display interfaces of
Interfaces assigned to
another MDC?
All interfaces on the
service module assigned to the
same MDC?
Yes
Contact the support

Solution

To successfully assign interfaces to a non-default MDC, make sure the following requirements are
met:
•
A service module on the device can belong to only one MDC.
•
All interfaces on a service module must be assigned to the same MDC by using a single
command.
•
Before assigning a service module to an MDC, assign all interfaces on the service module to
the MDC by using a single allocate command.
To reclaim a service module from the default MDC, only the undo location command is required.
You do not need to use the undo allocate command.
To resolve the problem:
1. Display the interfaces of MDCs.
[Sysname]display mdc interface
MDC Admin's interface(s):
M-GigabitEthernet1/0/0/0
FortyGigE3/4/0/2
FortyGigE3/4/0/4
FortyGigE3/5/0/2
FortyGigE3/5/0/4
MDC mdcA's interface(s):
M-GigabitEthernet1/0/0/0
GigabitEthernet3/3/0/2
GigabitEthernet3/3/0/4
MDCs
Yes
No
No
Reclaim the service
module and its
interfaces from the
MDC and re-assign
them
Assign all interfaces
on the service module
to the same MDC
FortyGigE3/4/0/1
FortyGigE3/4/0/3
FortyGigE3/5/0/1
FortyGigE3/5/0/3
GigabitEthernet3/3/0/1
GigabitEthernet3/3/0/3
GigabitEthernet3/3/0/5
80
Yes
Resolved?
No
Yes
Resolved?
No
End