HPE FlexNetwork 10500 SERIES Troubleshooting Manual page 72

9. Set switch startup mode
0. Reboot
Ctrl+F: Format File System
Ctrl+P: Skip Super Password
Ctrl+Y: Change Work Mode
Ctrl+R: Download application to SDRAM and Run
Ctrl+Z: Access EXTEND-ASSISTANT MENU
Enter your choice(0-9):
c. Enter Y to confirm the operating mode change.
PE mode is disabled. Are you sure you want to enable PE mode? [Y/N]Y
Done!
d. Enter 0 in the Extended Boot menu to reboot the device.
At startup, the device loads the startup images from the parent fabric. While the device is
starting up, the parent fabric displays messages about PEX port state changes, PEX
registration, and PEX startup.
6. Verify that you have specified the PEX startup software images for the device on the parent
fabric:
a. Execute the display boot-loader pex command and check the PEX startup software
images for the device.
b. If no PEX startup software images are specified for the device, use FTP or TFTP to transfer
the PEX startup software images of the device to the parent fabric.
NOTE:
You must store the image file in the root directory of a flash memory on the parent fabric.
c. Specify the file as the startup image file for the device. This example provides the following
methods:
<Sysname> boot-loader pex PEX-5700 file ipe flash:/5700PEX.ipe main
Verifying the IPE file and the images....Done.
Decompressing file 5700pex-10500-cmw710-boot-r7523P01.bin to flash:/
5700pex-10500-cmw710-boot-r7523P01.bin.....................Done.
Decompressing file 5700pex-10500-cmw710-system-r7523P01.bin to flash:/
5700pex-10500-cmw710-system-r7523P01.bin......................................
......................................................................Done.
d. Verify the result.
<Sysname> display boot-loader pex
Startup software image files for PEXs to load from the parent device:
PEX model: PEX-5120HI
None
PEX model: PEX-5700
flash:/5700pex-10500-cmw710-boot-r7523P01.bin
flash:/5700pex-10500-cmw710-system-r7523P01.bin
7. Verify that the PEX links are up:
a. Execute the display interface pex command.
<Sysname> display interface Pex
Pex101/0/0/29
Current state: UP
0
68