Acl Application Failure For Unsupported Acl Rules; Symptom; Troubleshooting Flowchart; Solution - HPE FlexNetwork 10500 SERIES Troubleshooting Manual

ACL application failure for unsupported ACL rules

Symptom

The system fails to apply a packet filter or an ACL-based QoS policy to the hardware. It displays an
error message that an unsupported rule exists in the ACL. The following is a sample error message:
Error: Slot=2 Fail to apply or refresh packet filter policy 3180 rule 5 on interface
Vlan-interface20. Not supported.

Troubleshooting flowchart

Figure 26 Troubleshooting ACL application failure
Failure to apply an ACL
Rule unsupported?
No
Contact the support

Solution

To resolve the problem:
1. Delete the unsupported rule and apply the packet filter or QoS policy again.
If the rule is indispensable and cannot be deleted, go to step 2.
2. If the problem persists, contact Hewlett Packard Enterprise Support.

ACL application failure for insufficient resources

Symptom
The system fails to apply a packet filter or an ACL-based QoS policy to the hardware. It displays an
error message that the hardware resources are not sufficient. The following are sample error
messages:
Error: Slot=2 Fail to apply or refresh packet filter policy 3001 rule 25 on interface
Vlan-interface6 due to lack of resources.
Warning: Classifier-behavior test in policy test applied on vlan 4079 failed in slot 2.
Reason: Not enough hardware resource.
Yes
Delete the
unsupported rule
73
Yes
Problem resolved?
No
End