HPE FlexNetwork 10500 SERIES Troubleshooting Manual page 50

Field
Transceiver info checksum error
Transceiver type and port configuration
mismatch
Transceiver type not supported by port
hardware
XFP
RX loss of signal
RX not ready
RX CDR loss of lock
RX power high
RX power low
TX not ready
TX fault
TX CDR loss of lock
TX bias high
TX bias low
TX power high
TX power low
Module not ready
APD supply fault
TEC fault
Wavelength unlocked
Temp high
Temp low
Voltage high
Voltage low
Transceiver info I/O error
Transceiver info checksum error
Transceiver type and port configuration
mismatch
Transceiver type not supported by port
hardware
2. Verify that the Tx and Rx optical powers of the transceiver module are within the correct range.
a. Execute the display transceiver diagnosis interface command to display the Tx and Rx
optical powers of the transceiver module.
<Sysname> display transceiver diagnosis interface
Ten-GigabitEthernet1/2/0/15 transceiver diagnostic information:
Current diagnostic parameters:
Description
Transceiver information checksum error.
Transceiver type does not match port configuration.
The port does not support the transceiver type.
Incoming (Rx) signal is lost.
Rx is not ready.
Rx clock cannot be recovered.
Rx power is high.
Rx power is low.
Tx is not ready.
Tx fault.
Tx clock cannot be recovered.
Tx bias current is high.
Tx bias current is low.
Tx power is high.
Tx power is low.
Module is not ready.
APD supply fault.
TEC fault.
Wavelength of optical signal exceeds the
manufacturer's tolerance.
Temperature is high.
Temperature is low.
Voltage is high.
Voltage is low.
Transceiver information read and write error.
Transceiver information checksum error.
Transceiver type does not match port configuration.
Transceiver type is not supported on the port.
46