NETWORK BOARD OPERATION
Installing the network board enables you to use the printer in the TCP/IP, IPX/SPX, AppleTalk,
DLC/LLC, Banyan VINES, DEC LAT and NetBEUI environments. Also, useful utilities such as
BR-Admin32 and network printing software for the administrator are included. For more
information about set up, see
6.1
Installing the Network Board
(1) Turn off the printer power, and then unplug
the power cord. Disconnect the interface
cable (printer cable) from the printer.
(2) Open the interface cover.
(3) Unscrew the two screws that secure the PCB access plate. Remove the plate.
(4) Remove the two screws securing the network
board cover plate and remove the plate.
(5) Unpack the network board.
section 3. INSTALL THE PRINTER in this
Fig. 2-31
2-45
HL-1850/1870N SERVICE MANUAL
Chapter.
Fig. 2-30
Fig. 2-32