CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
3.15
Drive Unit
(1) Place the printer body carefully on its left hand side so that the drive unit is at the top.
(2) Remove the three cup S tite 3x6 screws securing the reversing drive frame unit.
(3) Disconnect the harness connector and remove the bind M3x4 screw to remove the
reversing switch solenoid from the reversing drive frame unit.
Reversing drive frame unit
Reversing switch solenoid
Screw, bind M3x4
Screw, cup S tite 3x6
Fig. 4-72
Fig. 4-73
4-46
Printer body
Drive unit
Reversing drive frame unit