Brother HL-1850 Service Manual page 140

!
CAUTION:
• Never touch the surface of the halogen heater lamp.
• When securing the screw to assemble the halogen lamp connector plate, ensure you use
the plastic jig as shown in the figure below to avoid damaging the edge of the halogen
heater lamp.
Halogen heater lamp
(12) Lift and remove the heat roller 25 HE. The HR gear 34 HE will also come off.
(13) Remove the HR bearing 25 from the left hand end of the heat roller 25. To remove the HR
bearing 25 at the gear side, first remove the two washers, then remove the bearing.
Heat roller bearing 25
Heat roller 25 HE
!
CAUTION:
Halogen lamp
connector plate
Fig. 4-54
Washer
Fig. 4-55
4-33
CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
Screw, pan (washer) M 2.6x6
Plastic jig
HR bearing 25 HE
Washer
Heat roller gear 34 HE