Brother HL-1850 Service Manual page 146

NOTE:
When re-assembling the thermistor to the FU frame upper, ensure the direction of the
thermistor is correct referring to the figure below;
FU frame upper
(23) Remove the B 2.6x10 Taptite screw to remove the idle gear 13H. Hold slightly up the right
end of the eject roller and then remove the left end of the roller from the hook first, then
remove the eject roller from the FU frame upper.
NOTE:
When removing the left end of the eject roller, align the protrusion of the hook of the frame with
the concave part of the roller, and then pull the roller through underneath the protrusion.
Idle gear 13H
Taptite, B 2.6x10
Taptite, cup B M3x12
Fig. 4-64
FU frame upper
Fig. 4-65
4-39
CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
Thermistor
Concave part of the roller
Thermistor
Eject roller