Ip Addressing Considerations And The Wmc6300/7300 Card - Motorola MOTOMESH 1.2 Setup And Configuration Manual

Procedure 2-6 Determining Camera Host IP Address
To find the IP Host Address, right-click on the Camera device in the MeshManager Device Tree, and
1
select Current IP Address from the popup menu.
The next information dialog will display the Current IP address of the host.
2
To connect to the device's web page, right-click on the Camera device in the MeshManager Device
3
Tree, and select Launch Web Browser.
Web Browser will launch automatically.
4
5 End of Procedure.

IP Addressing Considerations and the WMC6300/7300 Card

The table below describes the possible effect of changing the Camera IP addressing scheme on the
WMC6300/7300 card.
Table 2-1 Changing IP Addressing and its Effects
MOTOMESH
Start with DHCP Network Server
Enable (True) supplies the address
What happens now The WMC6300/7300
if DHCP Enable is card will supply the
set to (False) address
What happens now Network Server
if switched back to supplies the address
DHCP Enabled
(True)
6881011Y68-B October 2006
MOTOMESH 1.2 Mesh Camera System Setup and Configuration Guide
Explanation
Camera will get
address when it
requests it
Camera will request
new address approx.
at the 50% point of
the lease time given
by the network
server
Because the lease
supplied by the
WMC6300/7300 card
is permanent the
Camera will not
request a new
address
2-17
Lease time is
set by the
Server's config
file
New lease time No Camera reboot
set by the required unless it is
WMC6300/7300 desired to
card is immediately force a
permanent new DHCP request
Will need to Camera will get
access the address from the
camera's web network server. (It
page (still may be the same
operating on its address that was set
static address) for static addressing
to reboot the if the server is
camera capable of supplying
this address)