Figure 1-10 Gooseneck Component Out Of The Box; Figure 1-11 Pelco Power Supply (Model #Wcsi-4 Is Outdoor Single 24Vac) - Motorola MOTOMESH 1.2 Setup And Configuration Manual

Figure 1-10
3. Setup the PELCO Power Supply (must be manually wired for 24 VAC capacity) with a Female
pigtail hanging out the source side AND the load/alarm wires connected/hanging out with the
appropriate slack/length. (A description list of compatible wire types are provided inside the
PELCO power supply lid.)
Figure 1-11
TIP FROM THE FIELD: The label on the inside of the PELCO Power Supply housing advises
the use of 20 to 12 AWG stranded wire. Tap A is the 24VAC and is the one to use. The chart also
shows AWG vs. distance.
Motorola CAN NOT recommend a specific wire configuration due to the fact that
the wire must be cut to length based on the termination/connection to the local
power source at a specific site, and that the installation must comply with local
building codes.
6881011Y68-B October 2006
MOTOMESH 1.2 Mesh Camera System Setup and Configuration Guide
Gooseneck Component out of the Box
PELCO Power Supply (Model #WCSI-4 is outdoor single 24VAC)
1-11