2-L - Hobart 5359D Operation And Maintenance Manual

OM 2012
(k) Remove the pipe plug in the cover and fill the filter (strainer) with clean
fuel oil. This step is known as "priming" the filter.
(1) Start the engine and check the fuel filter(s) to make certain there are no
leak.
(3) Change spin-on strainer and filter
Replacement cartridges are available from AC Delco under NOTE:
(4
04
(4
id)
the following part nunben;
Fuel Strainer - 25011011
Fuel Filter - 8921410
Change both cartridges after each 300 hours of engine operation.
Unscrew the filter (or strainer) and discard.
Fill a new replacement cartridge approximately two-thirds full with clean
fuel oil. Coat the seal gasket lightly with clean fuel oil.
install the new cartridge and tighten it two-thirds of a turn beyond gasket
contact.
Start the engine and check for leak. *
7. Engine Cooling System
A. Ge'neral
.
Cooling system service requires much more than maintaining the proper coolant
level ,in the radiator.
During warm seasOns and in warm climates, when plain water
is used as a coolant, the system must be protected against rust by a rust inhibitor
odd itive. During cold seasons and in cold climates, the system must, of course,
be protected against freezing. At no time should the system be operated for any
length of time on plain water, without a rust inhibitor or antifreeze. Draining,
cleaning, and filling the cooling system are covered in Para. 7, E thmugh H.
B. Radiator Cap
(1) General
A pressure valve is built into the radiator cap.
It is designed to open at a
pressure of approxhately seven pounds per square inch.
(2) Removal
To remove, turn the cap to the left (counterclockwise) to the safety stop.
When all pressure is released, press down on the cap and continue to turn
until the cap is free to be removed.
c
Au g 25 65
2-l
Page 13