Table of Contents
Advertisement
.--
_ -
L
i .-
SAFETY INSTRUCTIONS AND WARNINGS FOR ELECTKFCAL POWER EQUIPMENT I
WARNING
I
I
ELECTRIC SHOCK can kill.
Do not touch live electrical parts.
I
I
ELECTRIC ARC FLASH can injure eyes, burn skin,
cause
equipment damage, and
ignite combustible material.
Do
not use power cables to
break load and be sure tools don't cause short circuit+.
IMPROPER PHASE CONNECTION, PARALLELING, OR USE can damage this and attach{d
equipment.
I
IMPORTANT: - Protect
yourself and others.
Read and understand all the
instructions in this Operating/Instruction
Manual before
j
!
A.
B.
installing, operating, or servicing this equipment.
manual available for future use by all operators.
Keep th{s
I
GENERAL
Equipment that supplies electrical power can
cause
serious injury or death,
or damage to other equipment or property, if the operator does not str$ctly
observe all safety rules and take precautionary actions.
Safe practides
have developed from past experience in the use of power source equipmt&t.
SHOCK PREVENTION
I
Bare'conductors,
or terminals in the output circuit, or ungrounded,
I
electrically-live
equipment can fatally shock a person.
Have a tiompei&nt
electrician verify that the equipment is adequately grounded and learn what
terminals and parts are electrically HOT.
Use proper safety clothing;
procedures, and test equipment.
\
I
The electrical resistance of the body is decreased when wet, thus more
easily permitting dangerous currents to flow through It.
When fnspecting OF
servicing equipment, do not work in damp areas without being extremely
careful.
Stand on dry rubber mat or dry wood, use Insulating gloves that
are effective when dampness or sweat cannot be avoided.
Keep your clothing,
dry and never work alone.
,
!
I.
Installation and Grounding of Electrically Powered Equipment -Elet$tricab
equipment
must
be installed and maintained in accordance with the NatJonal j
Electrical Code, ANSI/NFPA 70, and other applicable codes.
A power discon-!
nect switch or circuit breaker must be located at the equipment.
nameplate for voltage, frequency, and phase requirements.
If only
Cheek the;
power is available,
3-phase j
of the 3-phase line.
connect any single-phase rated equipment to only two wipes
DO NOT CONNECT the equipment grounding &onductor (lea/d)
to the third live wire of the 3-phase line, as this makes the equipmelfit frame
electrically
HOT, which can cause a fatal shGky--
l
1
-w-e--
!
I
I
;
- ..-. m-t-.- ._ -.. .1
I
1
Dee 41184
I-.
-, - _- __ _ _ -
-_ -.. __ _..
I
Hide quick links:
Advertisement
Table of Contents
