Hobart 5359D Operation And Maintenance Manual page 133

OM 2012
(bb) Coiinect t!;e genergtor output ! o c buianced, three-phase load of 30
kilowatts.
(CC) Witfl gerierator running at 115 \I
AC no load, &perate the contactor
"on-off" switch (20, Fig. 2). if the average phase voit~gc: charged
more than 1. volt, or if outpuf is unsteady, adjust "damp" and "rate".
(dd) Turn the "damp" (1, Fig. 7) arlj3stir.g screw CLOCK\;r'ISE io Improve
response.
Turn COUNTERCLOCKWiSE to
improve
STABltiTY.
Gen-
erally the best adjustment is approximutely 3/4 of full CLOCKWISE
travel.
(ee) Turn the "rate" (2) adjusting 'screw to near full COUNTERCLOCKWISE
posit ion. Turn the screw siowly CLOCKWISE until the vollcge output
abruptly becomes STEADY. Continue turning the screw CLOCKWISE
5 deg to 10 deg past this point for bcst.'"rote" adjustment.
L
(ff) Tighten adju:ting screw locknuts after adjustment
is
compteted.
C. Basic Engine Ad justmcnts
Adjustment procedures applicable to the diesel engine are included in the Detroit
Diesel OpcrGtor's Manual, which is located in Chapter 6. Specific information
for this particular engine cpplication is listed in Figure 8.
(1) Exhaust valve adjustment
Refer to the Detroit Diesel Operator's Manual.
(2) Exhaust valve bridge adjustment
Refer to the Detroit Diesel Operator's Manual.
(3) Fuel injector timing adjustment
Refer to the Detroit Diesel O'perator's Manual.. Injector NOS.
Timing Gage Tool No. J1242.