Hobart 5359D Operation And Maintenance Manual page 102

OM 2012
(not in view)
1. Adjusting bracket screw
2. A Iternatar dr ive be It
3. Alternator pivot nuts and screw
4. Alternator
A lternattx EeJt Adjustment
..Figure 13
(c) Tighten adjusting bracket screw (1) and check belt tension (see Para. 9, B,
above).
(d) Repeat steps (b) and (c) until belt (2) is properly adiusted.
(e) Tighten pivot screw and nut (3) and retighten adjusting bracket screw (1).
(2) Fan belts
Adjust fan drive belts as follows: (See Fig. 14)
(a) Loosen four adjusting bracket screws (2) sufficiently to allow adjusting
bracket (4) to slide on support bracket (5).
2-1
Page 20
(b) Turn adjusting screw (1) clockwise to tighten fan belts (counterclockwise
to loosen hefts).
AW 25'85