Hobart 5359D Operation And Maintenance Manual page 120

L
OM 2012
.
1. Shut-down solenoid
9. Air shut-off valve shaft
2. Solenoid termina! (input)
10. Starter cut-out switch
3. Solenoid terminal (gramd) 11. Switch adjusting nuts
4. Latch crm adjusting nuts
12. Switch actuating rod
5. Switch bar attaching nut
13. Switch actuating bar
6. Latch actuating arm
14. Latch
can a
7.' Latch
15. Solenoid plunger rod
8. Latch reset lever
.
Engine Shut-Down Solenoid with Linkage, and Starter Cut-out Switch
Figure 3
(dd) Disconnect jumper leads.
(b)
Flashing exciter field without test box.
ba)
Remove test receptacle cover (1-3; Fig. 6). Use two test leads
equipped with a test prod on one end and an "alligator" clipon
the other.
insert the test prod of one lead in terminal "D" of the
test receptacle (see Fig. 5), and connect the other end of the lead
to a good GROUND. tnsert the test prod of the second lead in
terminal "F" of the test receptacle and momentarily touch the
other end (alligator clip) to the "hot" terminal (4, Fig. 4) on the
starter soleno id to flash the field.
CA1JTlON: FWSHING THE FIELD IN A REVERSE DIRECTION
COULD CAUSE DAMAGE TO VOLTAGE REGULATOR
DIODES.
2-3
Aug 25 185
Page 6