Hobart 5359D Operation And Maintenance Manual page 138

OM 2012
1. Connector
2. Magnci-ic pickup
Magnetic Pickup
Figure IG
.
(3) Governor control
unit
cdjustment
.
Before making on adjustment to the control unit (Fig. I?), make certain that
linkage batween actuator and fue I control iever (Fig. 9 ), is free and proper/y
adjusted. There must be no lost motion or "play" in the linkage. Be sure mag-
netic pickup is producing a strong, normal output.
There are three adjustnant controls on the unit (see Fig. 12). They
are
identified
US:
FREQ. ADJUST - Adiusts engine speed and gcneratos frequency.
GAIN and STABILITY -Adjust engine response time end stability.
To adjust control unit, proceed as foiiow,:
(a) If the control box is being adjusted fcx the first time, set adjustment controL 05
folloVV5:
FtIE Q. control
- Turn adjusting screw at least 22 turns counterclcckwise. This
will pasitiveiy insure that its adjusied position will be at MiNIMUM
speed.
2-3
Paae 24
Aug 25 '85