Emerson Unidrive M100 Control User Manual page 83

Safety Product Mechanical
information information installation
Trip
d.Ch Drive parameters are being changed
A user action or a file system write is active that is changing the drive parameters and the drive has been commanded to
enable, i.e. Drive Active (10.002) = 1.
97
Recommended actions:
• Ensure the drive is not enabled when defaults are being loaded
dEr.E Derivative file error
Derivative file error with sub-trips:
Sub-trip
246
Recommended actions:
• Contact the supplier of the drive.
Unidrive M100 / M101 Control User Guide
Issue Number: 1
Electrical Getting
installation started parameters
Reason
1 The derivative file is missing or is invalid
The derivative file does not match the
2
control board hardware
The derivative file has been changed for a
3
file with a different derivative number.
Basic Running the
Optimization
motor
Diagnosis
Occurs when the drive powers-up. Load valid derivative file
matching the control board hardware.
Occurs when the drive powers-up. Load valid derivative file
matching the control board hardware.
Occurs when the drive powers-up or the file is
programmed. The file tasks will not run.
Advanced
NV Media Card Diagnostics
parameters
Comments
UL Listing
83