Optional Driftwood Log Set Installation - Regency Fireplace Products City Series Owners & Installation Manual

installation-media

Optional Driftwood Log Set Installation

CITY SERIES 60 - LOG INSTALLATION
Read the instructions below carefully and refer to the images. If the logs are broken, do not use them in the unit until they are re-
placed. Broken logs can interfere with pilot operation.
Improper positioning of the logs may create carbon build-up and alter the unit's performance, which is not covered under warranty.
*Dark brown paint is included if touch ups are required.
1. Shut off the gas and electrical supply and allow the unit to cool to room temperature.
2. Remove the barrier glass (if already installed) and firebox glass (see manual).
3. Carefully remove the logs from the packaging and unwrap them. The logs are fragile; handle with care. Never force
them into position.
Accessories
1 Logs 1-11 (each log's number appears on its underside)
2 2 lb Black Fireglass (purchased separately from log set)
3 Glowing Wool (supplied with unit)
4 3/4" Crushed black glass or iceburg chips (purchased separately from log set) or Andriron embers
Volcanic stones cannot be used with the driftwood log set.
4. The next steps are done at side A of the unit, where the valve and IFC board are located.
106 | City Series CST60E
920-393
1
CITY SERIES 60
07.14.21