KVH Industries TracVision G6 Installation & Technical Manual page 156

TracVision G6 Technical Manual
RF Board Commands
152
G.6 RF Board Commands
Serial Communications, Status/Polarization Report, Tone Changes
Table G-6
Function:
Command:
Response:
Where:
* The Mode bit is used to evaluate the Satellite, Polarization & Band
combination vs. the Frequency/Symbol Rate/FEC currently in RAM. This
bit will be set to invalid if the Frequency for the selected combination is
set to 0x0000; otherwise it will be set to valid. For example the Mode bit
will be set to invalid when the frequency is set to 00000 to indicate that
there is not a frequency to track for the LNB tone and voltage setting.
Report RF Tracking Parameters
Function:
Command:
Response:
Where:
* This command dumps all eight combinations of the Satellite/Freq/Sym/
FEC/ID/POL/Band/Decode currently stored in RAM.
start serial communications, reports status &
polarization/tone changes
@S
S,s,p,b,m <cr> every 5 seconds until ><cr>is
returned from system software
s = Satellite (a = Primary, b = Secondary)
p = Polarization (v = Vertical, h = Horizontal,
r = Right, l = Left, x = No LNB Power)
b = Band (h = High Band, l = Low band, g = Latin
America, u = USA)
m = Mode (v = Valid, i = Invalid)*
reports all RF tracking parameters for primary &
secondary satellites*
@SATCONFIG
F,x,fffff,S,C,ID,P,B,D <cr>
x = Satellite (a = Primary, b = Secondary)
fffff = Frequency in MHz (00000 and 10700 to
12700)
S = Symbol rate in Mbit/Sec (1000 to 29999)
C = FEC code rate (valid rates = 12, 23, 34, 56,
67, 78)
ID = Satellite Network ID in hexidecimal format
(valid range = 0x0000 to 0xffff hex)
P = LNB Polarization (v = Vertical, h = Horizontal,
r = Right, l = Left)
B = the LNB down conversion frequency (l=low,
h=high, G=Latin America, U=USA)
D = decoding type (0=test, 1=DSS-A, 2=DSS-B,
3=DVB)
54-0161