Table of Contents
Advertisement
TracVision G6 Technical Manual
Rotating Card Display – Removing
the Backplate
132
Panel Mounting
1. Using Template D-2, mark lines for the cutout area
in the mounting surface. Cut away the material
inside the lines and clean up to the lines with a
file. Test-fit the display unit in the cutout opening.
2. Remove the two 6 mm machine screws from the
back of the display unit. Insert the display unit
into the cutout; place the panel mounting bracket
clamp in position behind the display unit. Reverse
the 6 mm screws and reinsert into the case through
the bracket clamp. Tighten the screws to secure in
place.
Wiring the Rotating Card Display
1. Refer to Figure D-2. To remove the backplate,
undo 8 screws (a) and withdraw the backplate
assembly. Separate the two pigtail plug connectors
from the card assembly.
Figure D-2
2. Pass the power supply and data cables through
their packing glands (b, c, and d) from the outside
and tighten the gland nuts before connecting
wires.
8 Screws (a)
FUSE (1A)
PACKING GLANDS
(b)
(c)
(d)
54-0161
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
