Deleting Sequence
Terms (tsq -d)
U>tsq -d 2
U>tsq -d 3
U>tsq
tif 1 addr=443
tif 2 addr=5c2
tsto all
telif addr=40f
Changing the
Trigger Position
(tp)
U>tp
tp s
Getting Started 2-30
You delete sequence terms using the -d option to the tsq (trace se-
quencer specification) command. For example, to delete the terms
which were just inserted, enter the following commands.
After a term is deleted, the remaining terms are renumbered; this is
why the third term is deleted above instead of the fourth (which no
longer exists after the tsq -d 2 command). Enter the tsq command with
no options to verify that the sequencer is as it was before inserting and
deleting terms.
The preceding trace specification caused the analyzer to fill trace mem-
ory with the states which followed the trigger. The reason the trigger
appears at the start of the trace list is because of the current trigger posi-
tion specification. To see the current trigger position specification, en-
ter the tp (trigger position) command with no options.
The trigger position default is s, which specifies that the trigger appears
at the start of the trace. You can also specify that the trigger appear in
the center of the trace with the c option, or that the trigger appear at
the end of the trace with the e option; additionally, you can specify a
certain number of states to appear before (-b) or after (-a) the trigger in
the trace. For example, changing the trigger position so that 10 states