Connecting Probe Wires to the Target System
Caution
Turn OFF target system power before connecting analyzer probe
wires to the target system. The probe grabbers are difficult to handle
with precision, and it is extremely easy to short the pins of a chip (or
other connectors which are close together) with the probe wire while
trying to connect it.
You can connect the grabbers to pins, connectors, wires, etc., in the tar-
get system. Pull the hilt of the grabber towards the back of the grabber
handle to uncover the wire hook. When the wire hook is around the
desired pin or connector, release the hilt to allow the tension of the
grabber spring to hold the connection. (See figure 4-5.)
Using the External Analyzer 4-6