Table of Contents
Advertisement
Getting Started
Introduction
This chapter shows you how to use the emulation analyzer from mak-
ing simple measurements to searching for a sequence of states. It does
not describe how to access or use the full capability of the analyzer (see
the chapter on "Accessing Full Analyzer Capability").
This chapter:
Describes the sample program on which example measurements
•
are made.
Describes the default, power-up condition of the analyzer (includ-
•
ing how to: initialize the analyzer, start the trace measurement, halt
the trace, display the trace status, display the trace, and change the
format of the trace listing).
Describes expressions allowed in trace commands.
•
Shows you how to specify a simple trigger.
•
Shows you how to specify a storage qualifier.
•
Shows you how trace prestore is used.
•
Shows you how to change the count qualifier.
•
Shows you how to use the sequencer.
•
Shows you how to change the position of the trigger state in the
•
trace.
2
Getting Started 2-1
Advertisement
Table of Contents
