Expressions in
Trace Commands
any/all
never/none
arm
label=<value>
label!=<value>
label=<value> and label=<value> ...
label!=<value> or label!=<value> ...
label=<value>..<value>
label!=<value>..<value>
Note
Note
Tokens
Getting Started 2-10
So far, the default trace specifications have been used, and you have not
entered any expressions. Expressions are used in commands which
qualify the trace. This section describes the expressions which may be
used in trace commands. Expressions may be specified in the following
forms (the pound sign, # , appears before comments):
If you wish to specify an expression such as "label = < value> and la-
bel != < value> ", you must configure the analyzer so that you have
access to its full capability.
Only one range resource is available. You can, however, use this
range (or "not this range") in more than one trace command.
The tokens any or all specify any or all conditions; you can use these to-
kens interchangeably. The tokens never or none specify false condi-
tions; they are used to turn off qualifiers. The never and none tokens
may also be used interchangeably. The arm token represents a condi-
tion external to the analyzer. Arm conditions are described in the
"Making Coordinated Measurements" chapter.
# special tokens
# this condition
# not this condition
# this range
# not this range