Table of Contents
Advertisement
U>trng addr=500..5ff
U>trng data=0080..008f
U>tsto p1 | p2 | p3 | r
U>tsto p5 ~ p6 ~ arm
U>tsto p1 | p2 ~ p3
!ERROR 1249! Invalid qualifier expression: ~ p3
U>tsto p1 ~ p2 ~ p5
!ERROR 1249! Invalid qualifier expression: p5
U>tsto p1 ~ p2 and p5 | p6
U>tsto p3 | p4 | !r or p7
U>tsto p8 ~ arm and p1 ~ p2
U>tsto p1 and p2
!ERROR 1249! Invalid qualifier expression: p2
Again, values may be specified as described in the "Getting Started"
chapter. Examples of valid range specifications follow.
Combining Resources
The eight patterns (p1..p8), the range (r for "in range" or !r for "not in
range"), and the arm qualifier (described in the "Making Coordinated
Measurements" chapter) are grouped into the two sets shown below.
Set 1: p1, p2, p3, p4, r, and !r.
Set 2: p5, p6, p7, p8, and arm.
Resources within a set may be combined using one of the intraset op-
erators, | (OR) or ~ (NOR). Examples of some valid and invalid in-
traset combinations follow.
This expression is invalid because you cannot use both | (OR) and ~
(NOR) operators within the same set.
This expression is invalid because you cannot combine resources from
different sets with the | (OR) or ~ (NOR) operators.
The two sets can be combined with the and and or interset (between
set) operators. Interset operators are also called global set operators.
The intraset (within a set) operators (~ , | ) are evaluated first; then, the
interset operators are evaluated. You cannot use interset operators on
patterns in the same set. Examples of some valid and invalid combina-
tions of the two sets follow.
Accessing Full Analyzer Capability 3-5
Advertisement
Table of Contents
