Installing Modules - Ruijie Networks RG-S8605E Hardware Installation And Reference Manual

 Steps for installing the M10-FAN-F fan tray:
1) Install the fan tray into the fan slot in the front panel of RG-S8610E. Note the direction identifier of the fan tray's name
to ensure the correct direction.
2) Tighten the captive screws on the fan tray with a screwdriver.
Figure 3-26 Installing M10-FAN-F Fan Tray
Do not remove the fan tray forcibly. You can use the fan handle. Otherwise, component damage may occur,
which causes deformation of the fan tray, and the fan tray cannot be removed.

Installing Modules

Always wear an anti-static wrist strap when installing the module and the metallic part of the anti-static wrist strap should
be fully touched with the skin. Besides, for the sake of security, please not touch any component of the module.
Do not hold the edge of the PCB or collide the components on the PCB.
Do not plug/unplug a supervisor module , service module or switch fabric module forcedly, use the ejector.
 Select Slots