Swing Arm Kit Installation - Advantech WP-75**-**10/40 User Manual

Swing Arm Kit Installation

Select a flat surface of adequate strength, ensuring there will be proper ventilation and maneuvering space.
Please use the right tools and accessories according to the surface material (drywall, concrete, solid wood,
etc.) to securely support the system box. A fully equipped system may weigh up to 5.5 kg.
1. Drill four holes in the surface following the rectangular mounting plate layout as shown below. The
rectangular drill pattern should be 130mm wide (horizontal) and 130mm high (vertical). Secure the
swing arm to the surface with four screws.
NOTE:
2. Next, prepare the arm to be attached to the WP-65X1. Release the two thumb screws and remove
the VESA holder plate by sliding it in the direction of the arrow.
VESA Holder
Wall Mount Holder
Wall mounting screws are not supplied, as different types of walls require
different types of screws. Please be sure the mounting screws used can support
the weight of the unit.
27