ACME LED WAVE 100 User Manual page 9

Show Mode
Press the MENU button up to when the
and the display will blink. Use DOWN and UP button to select the
(show 1) or (show 2). Once the mode has been selected, press the ENTER button to setup
or automatically return to the main functions without any change after one minute. To go back to
the functions without any change press the MENU button again.
Slave Mode
Press the MENU button up to when the
and the display will blink. Use DOWN and UP button to select the
master) , (set the fixture as slave 1) or
has been selected, press the ENTER button to setup or automatically return to the main functions
without any change after one minute. To go back to the functions without any change press the
MENU button again.
Display Inverse
Press MENU button until
(display normal) or
LED display
Press the MENU button up to when the
and the display will blink. Use DOWN and UP button to select
(display off 20 seconds after exit menu) mode. Once select, press ENTER button to setup or
exit menu mode without any change after one minute. Back to the functions without any change
press MENU button again.
Manual setting color
is showing on the display. Pressing ENTER button
is showing on the display. Pressing ENTER button
is blinking on the display. Use DOWN and UP button to select
(display inverse), press ENTER button to setup.
is shown on the display. Pressing ENTER button
8B
(Random show),
(set the fixture as
(set the fixture as slave 2). Once the mode
(display always on) or