Dmx512 Connection - ACME LED WAVE 100 User Manual

4.5 DMX512 Connection

The DMX512 is widely used in intelligent lighting control, with a maximum of 512 channels.
Termination reduces signal errors and to avoid signal transmission problems
and interference. It is always advisable to connect a DMX terminal (Resistance
120 ohm 1/4W between pin2 (DMX-) and pin3 (DMX+) of the last fixture).
1. If you using a controller with 5 pins DMX output, you need to use a 5 to 3 pin adapter-cable.
2. The last units DMX cable has to be terminated with a 120 ohm 1/4W resistor between pin
2(DMX-) and pin 3(DMX+) of a 3-pin XLR-plug and plug it in the DMX-output of the last unit.
3. Connect the unit together in a `daisy chain` by XLR plug from the output of the unit to the
066 ~ 076
077~ 087
088 ~ 098
099 ~ 109
110 ~ 120
121 ~ 127
128~ 187
188 ~ 196
197 ~ 255
ATTENTION
Color 3
Color 3  Color 4
Color 4
Color 4  Color 5
Color 5
Color 5  Open
Continuous Rotation
CW Rotation: fast  slow
CCW Rotation: slow  fast
12B
Stop