Operating Settings Configuration; Home Screen; Start Address; Network Setup - Chauvet maverick mk1 spot User Manual

Hide thumbs Also See for maverick mk1 spot:
Table of Contents

Advertisement

O
PERATION

Operating Settings Configuration

Home Screen

The Maverick MK1 Spot has a home screen that shows the protocol mode, the IP address or DMX
address, the DMX personality, and the current product temperature. To see the home screen, press.
<MENU> repeatedly until it appears on the display.

Start Address

To set the starting address, set the Control Mode and then follow the instructions below:
1.
Press <MENU> repeatedly until the Home Screen shows on the display. Press <ENTER>.
2.
Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Start Address, or touch the display where
it says Start Address.
3.
If using the buttons instead of the touchscreen, press <ENTER>.
4.
Enter the starting address (001–512) with one of the following methods:
Type the address number using the number pad that shows on the touchscreen display.
Using the buttons (or the button icons on the sides of the display),
a.
Use <LEFT> or <RIGHT> to select the digit to be altered.
b.
Use <UP> or <DOWN> to increase or decrease the number value of that digit.
c.
Repeat until the address is set as desired.
5.
Press <ENTER>.

Network Setup

The universe of the TCP/IP protocol will be the universe of the DMX function.

Ethernet To DMX

The Maverick MK1 Spot can convert a single Ethernet input signal to a single DMX output signal.
To activate or deactivate the Ethernet to DMX function, do the following:
1.
Press <MENU> repeatedly until the Home Screen shows on the display. Press <ENTER>.
2.
Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Network Setup, or touch the display where
it says Network Setup.
3.
If using the buttons instead of the touchscreen, press <ENTER>.
4.
Use <UP> or <DOWN> to select Ethernet to DMX, or touch the display where it says Ethernet
to DMX.
5.
If using the buttons instead of the touchscreen, press <ENTER>.
6.
Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select NO (deactivate) or YES (activate), or touch
the display where it says the desired setting.
7.
Press <ENTER>.
Maverick MK1 Spot User Manual Rev. 1
Page 15 of 38

Advertisement

Table of Contents
loading

Table of Contents