Table of Contents
Advertisement
O
PERATION
Artnet IP Address
To set the IP address, do the following:
1.
Press <MENU> repeatedly until the Home Screen shows on the display. Press <ENTER>.
2.
Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Network Setup, or touch the display where
it says Network Setup.
3.
If using the buttons instead of the touchscreen, press <ENTER>.
4.
Use <UP> or <DOWN> to select IP, or touch the display where it says IP.
5.
If using the buttons instead of the touchscreen, press <ENTER>.
6.
Set the IP address (from 000.000.000.000 to 255.255.255.255) with one of the following methods:
Through the touchscreen:
a.
Touch the display where it shows the byte (set of three numbers) to be changed. Use the
number pad on the display to enter the desired number.
b.
Use the number pad on the display to enter the desired number.
c.
Repeat until the IP address is set as desired.
With the buttons:
a.
Use <LEFT> or <RIGHT> to select the byte (set of three numbers) to be changed).
b.
Use <UP> or <DOWN> to increase or decrease the value.
c.
Repeat until the IP address is set as desired
7.
Press <ENTER>.
Subnet Mask
To set the Subnet Mask, do the following:
1.
Press <MENU> repeatedly until the Home Screen shows on the display. Press <ENTER>
2.
Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Network Setup, or touch the display where
it says Network Setup.
3.
If using the buttons instead of the touchscreen, press <ENTER>.
4.
Use <UP> or <DOWN> to select SubMask, or touch the display where it says SubMask.
5.
If using the buttons instead of the touchscreen, press <ENTER>
6.
Set the Subnet Mask (from 000.000.000.000 to 255.255.255.255) with one of the following
methods.
Through the touchscreen:
a.
Touch the display where it shows the byte (set of three numbers) to be changed. Use the
number pad on the display to enter the desired number.
b.
Use the number pad on the display to enter the desired number.
c.
Repeat until the IP address is set as desired.
With the buttons:
a.
Use <LEFT> or <RIGHT> to select the byte (set of three numbers to be changed).
b.
Use <UP> or <DOWN> to increase or decrease the value.
c.
Repeat until the IP address is set as desired
7.
Press <ENTER>.
In DHCP or Static IP Mode, the IP and SubMask menu settings have no effect on
the product.
Maverick MK1 Spot User Manual Rev. 1
Page 17 of 38
Advertisement
Table of Contents
