Table of Contents
Advertisement
Operation
Configuration (Operating Settings)
Power Mode
The power mode determines the maximum brightness to match the output of the Ovation ED-200WW to
that of either a 750 W or a 575 W incandescent lighting product.
1.
Go to the POWER MODE main level
2.
Select either 750W or 575W.
Dimmer Profiles
This setting determines how fast the output of the Ovation ED-200WW changes when you modify the
output value.
1.
Go to the SETTING main level.
2.
Select the DIMMER programming level.
3.
Select a dimmer speed (OFF, DIM1, DIM2, or DIM3).
OFF: The output is proportional (linear) to the dimmer channel value.
DIM1-3: The output follows the dimmer value based on the corresponding dimmer speed,
DIM1 being the fastest.
Note: Set to DIM3 for optimum performance in DMMR mode.
Dimmer Curves
These options simulate the dimmer curve of an incandescent lighting product.
1.
Go to the SETTING main level.
2.
Select the CURVE programming level.
3.
Select a dimmer curve (OFF, CURVE1, CURVE2, or CURVE3)
OFF: The output is proportional (linear) to the dimmer channel value.
CURVE1-3: The output follows the dimmer value based on the corresponding dimmer
curve, CURVE1 being the most direct.
Note: Set to CURVE3 for optimum performance in DMMR mode.
Performance Mode
These options determine the method by which the Ovation ED-200WW maintains cooling.
1.
Go to the SETTING main level.
2.
Select the PERFORM programming level.
3.
Select either LIVE (fans are used) or STUDIO (output power level is limited).
Factory Reset
This option restores the Ovation ED-200WW to factory default settings.
1.
Go to the SETTING main level.
2.
Select the RESET programming level.
3.
Enter the pass code (<UP>, <DOWN>, <UP>, <DOWN>, <ENTER>).
LED Frequency
This option changes the Pulse Width Modulation (PWM) frequency of the LEDs on the Ovation ED-
200WW.
1.
Go to the LED Frequency main level.
2.
Select PWM Frequency (600Hz, 1200Hz, 2000Hz, 4000Hz, 6000Hz, or 25Khz).
System Information
This option displays the current firmware version and RDM UID and label.
1.
Go to the Information main level.
2.
Select Version, or RDM.
Ovation ED-200WW User Manual Rev. 1
Page 13 of 28
Advertisement
Table of Contents
